• Bilge Components

    by Published on May 15th, 2010 21:22     Number of Views: 12666 
    1. Categories:
    2. All Topics,
    3. Bilge Components

    Wouldn't it be nice to be warned if your boat was taking on a dangerous amount of water? While many newer boats have bilge high water alarms installed, chances are if your boat is more than 10 yrs old you are missing this critical safety component. The only warning you may have of excess water in your bilge is the fact that your bilge pump is running continuously. But if your engines are running can you hear your bilge pumps?
    ...
    by Published on May 14th, 2010 19:36     Number of Views: 5025 
    1. Categories:
    2. All Topics,
    3. Bilge Components

    The thought of servicing a bilge pump is enough to make even the most savvy mechanic shiver. By their nature it is hard to access them on most boats. With this bracket assembly we will make that job much easier.
    You will need a piece of aluminum stock 6 inches wide, at least 12 inches long and approximately 3/8 inch thick. The actual length will be determined by the mounting method you choose as we discuss below.
    ...
  • Recent Forum Posts

    Cap'n Ray

    Welcome aboard Dano! Good to have you on the...

    Welcome aboard Dano! Good to have you on the forum. Good lookin boat you have there, looks like a nice spot too! Hope you find lots of useful information here, and share your adventures with us....

    Cap'n Ray Yesterday, 21:58 Go to last post
    Cap'n Ray

    You MIGHT be able to free it by spraying a little...

    You MIGHT be able to free it by spraying a little wd40 (or your preferred substitute) and working the shifter back and forth. If you're reasonably mechanically inclined, disassemble the entire unit,...

    Cap'n Ray Yesterday, 21:55 Go to last post
    Cap'n Ray

    You're probably correct. If you're removing the...

    You're probably correct. If you're removing the wire at the sender it is almost certainly your culprit. Let us know how the swap goes.

    Cap'n Ray Yesterday, 21:52 Go to last post
  • Twitter